Plastics. Unsaturated-polyester resins. Determination of reactivity at 130°C1 Scope This International Standard specifies a method of measuring the time required for the temperature of a solution of unsaturated polyester resin and a catalyst, heated in a thermostatically controlled bath at 130 C, to rise from 80 C to 140 C, from 80 C to the maximum temperature reached; the maximum temperature reached; the speed of the reaction, determined by drawing a tangent at the point of inflection of the temperature time curve. It

Type B: Thick wall – internal diameter up to 165

BS EN 16808 specifies general safety requirements for the design

Limiting values to specified distillation characteristics are applied to most distillate petroleum products and liquid fuel specifications to control end-user performance and to regulate the formation of vapours which may form explosive mixtures with air

This method has been validated with special emphasis around 5 mg/m3 on an average half hour sampling time

specifies a container to store image metadata

This document is not applicable to tips fixed to the handpiece with a screw

Symbols for medical device labelling

These products are delivered in sheet

A video transmission device supporting compliance to the requirements of this standard with the help of Web services according to the specification of this part is declared as compatible to IEC 62676‑2 Web service Interoperability

enabling the development of an optimal environment for the stability and safety of chemical storage and usability

If the sheet on the upper surface is covered with permanent light surface protection and where the reinforcement is placed in the cross section visually closer to the upper surface

BS EN 14956 discusses test specimen